CLR 1020 / CLH 6021

Semi-flexible epoxy adhesive and casting system. An unfilled, semi-flexible two component epoxy system. Its low mixed viscosity makes it suitable for potting and encapsulating electronic components. CLR 1020 / CLH 6021

CLR 1026 / CLH 6021

Low viscosity, semi-flexible. An unfilled, semi-flexible two component epoxy system. Its low mixed viscosity makes it suitable for potting and encapsulating electronic components. CLR 1026 / CLH 6021

CLR 1066 / CLH 6330

Low Exotherm, Low shrinkage epoxy. A two component, long pot life casting system with low exotherm, low shrinkage and excellent thermal shock resistance. CLR 1066 / CLH 6330

CLR 1066 / CLH 6930

Large mass casting, 30-minute pot life. Masses larger than 6Lbs. A two component, filled, room temperature cure epoxy system.the product has a low exotherm and low shrinkage, making it suitable for castings larger than 3 kgs. CLR 1066 / CLH 6930

CLR 1730 / CLH 6372

Heat and chemical/fuel resistant adhesive/laminating. A two component heat and chemical resistant epoxy laminating system. CLR 1730 / CLH 6372

CLR 3080 / CLH 6372

General Adhesive room temperature cure. Resistant to Toluene, Ethanol, Aviation Gas and Diesel Fuel. A low viscosity, two component, chemical resistant epoxy system. Post cured material has excellent resistance to most petroleum based fuels and solvents during exposure at ambient and elevated temperatures. CLR 3080 / CLH 6372

CLS 9600

High Temperature. A single component, 100% solids, low viscosity, impregnating compound for coils and transformers. This product is also suitable for sand casting. CLS 9600

XRD 1014 / XHD 1015

High temperature clear epoxy. An unfilled, heat resistant, clear laminating system. Products low viscosity gives the system excellent wet-out properties to fibreglass and other reinforcing fibres. The material exhibits high physical strengths and modulus with moderate post cure temperatures. XRD 1014 / XHD 1015

XRD 1018 / XHD 1019

1:1 Mix Ratio, 130°C Operating, General Purpose, Low cost. A two component, room temperature cure semi-flexible, flame retardant, epoxy system. The system was developed for potting/casting of electrical and electronic components. Its use of non-abrasive fillers and convenient 1 to 1 ratio by volume, make it ideal for use in machine dispensing equipment. This product meets UL94-V0 in house flammability testing. XRD 1018 / XHD 1019